The XP-CPRO2L lift access controller can be used to control the access to the levels in the building. It uses the Mio-R16 to control the access to each of the floor. Each card holder is assigned with a floor zone setting which contains the information of how he/she can access to each of the level.
You may configure that the card holder only able to access to a certain levels but denied entry into others.
The XP-CPRO2L lift access control system can be used together with other MicroEngine’s door access equipments under the management of a single software system – xPortal2007 or xPortalNet. In this way, the accessibility of the card holder into each of the area including the control inside the lift can be managed from a single point.
| No | Features | Functions |
| 1. | Autonomy | Distributed data and processing |
| 2. | Downlink | 2 wire RS485 |
| 3. | No of CDP | 2 |
| 4. | No of floor | 64/COP |
| 5. | Battery backed real time clock | Yes |
| 6. | Onboard rechargable battery | Yes |
| 7. | Card Number | 6 Digits |
| 8. | Continuous reads when door left open | Yes |
| 9. | Operating modes | Card only |
| 10. | Time Zone | 255 |
| 11. | Time Set | 255 each with 3 intervals |
| 12. | Holidays | 30 |
| 13. | Onboard Watchdog Circuit | Yes |
| 14. | Auto lock release by time zone | Yes |
| 15. | Cardholders | 10,000 |
| 16. | Events | 20,000 |
| 17. | RAM memory | At least 128 KByte |
| 18. | RAM protected by on board battery | Yes |
| 19. | Firmware EPROM / flash memory | At least 128 KByte |
| 20. | Addressing via switch | Yes |
| 21. | Onboard buzzer | Yes |
| 22. | Communication ports | RS485 |
| 23. | Polarity protection for power connector | 4 digits |
| 24. | Power | 12VDC |
| 25. | Relay interface unit | MTR16 |
| 26. | Reader interface unit | MK800 |
