Description
The SplashGard™ system is a dual-component specialized coating and structural reinforcement solution specifically designed for use in wet or submerged conditions. SplashGard™ consists of two components: SplashBond™ Adhesive and Splash Wrap, a fiberglass cloth impregnated with moisture cured urethane (MCU) resin. The innovative corrosion barrier system can be applied underwater and adheres easily to wet steel surfaces. It not only arrests corrosion and wave action, but also provides structural reinforcement, making it an ideal option for use on risers.
Technical Specs
|
Mechanical Properties Attribute–Tensile Strength Method– ASTM D3039 Value– 51,800 psi Attribute–Tensile Modulus Method–ASTM D3039 Value–3.01 x 106 psi Attribute– Poisson's Ratio Method– ASTM D3039 Value–0.077 |
Thermal Properties Attribute– Thermal Expansion Method– ASTM E831 Value– 10.2 μm/m/°C Attribute– Heat Distortion Temperature Method– ASTM D648 Value– 205 °C Attribute– Max Operating Temperature Method– ASME PCC-2 Value– 185 °C Attribute– Application Temperature Value– -50°F to 120°F -46°C to 49°C |
|
System Properties Attribute– Ply Thickness Value– 22 mils (0.022 inches) Attribute– Working Time Value– 20 – 30 minutes Attribute– Set Time Value– 2 hours Attribute– Cure Time Value– 24 hours Attribute– Shelf Life Value– 1 year with proper storage Attribute– Stocked Sizes Value– From 2" X 12' to 12" X 90' |
 |
1. Surface Preparation Remove all soft coatings and media blast the pipe to provide an anchor pattern (NACE 1 preferred). On dry surfaces, wipe the surface with a solvent such as Acetone, Toluene, or MEK. For structural repairs, mix and apply filler putty or paste to any defects. |
 |
2. Apply SplashBond Mix equal parts of the SplashBond™ Epoxy Primer until uniform. Apply the primer to the pipe surface as instructed. Allow the primer to sit until a “peanut butter” thickness is achieved. |
 |
3. Apply SplashWrap Follow the wrapping instructions for Pipe Wrap™ or A+ Wrap™, as applicable for the repair. |
 |
4. Apply SplashBond Outer Coat Allow the material to cure. Then, mix and apply a coating of SplashBond™ as an outer coating. |
Malaysia
