Description
Features:
- Repairs leak in 30 minutes
- Applicable to pipes up to 18″ (457 mm) diameter
- Applicable on any metal or non-metal pipes
- Repairs T-joint, elbow joint, valve thread, valve body
- Withstand pressure up to 400 psi (28 kg/cm2)
- Withstand temperature up to 200 °C (392 °F)
- Safe for drinking water and resistant to most chemicals
- Reinforce and strengthen pipe after repair
- Permanent repair and extend service life of pipes
Applicable Material:
| Steel |
Stainless Steel |
| Copper |
Polyethylebe |
| Aluminium |
Polypropylene |
| Galvanized Steel |
Cast-iron |
| PVC |
Concrete |
| CPVC |
FRP/GRE |
Chemical Resistance:
- Oil
- Water (drinking water, wastewater, steam)
- Solvents (acetone, toluene, MEK, ethyl alcohol)
- Mild acids (hydrochloric acid, sulfuric acid) and alkalis
- Chemical (ethylene glycol, xylenes, ammonia)
- Hydrocarbons
- Bases
- Slurries
- Fuels (petroleum, diesels, gasoline)
- Gases (LNG, LPG)
- Organic salts
Working Time: 1 minute at 30 °C (86 °F)
Curing Time:
- 30 minutes at 30 °C (86 °F)
- Heat may be applied to decrease curing time
- Unopened foil pouch may be immerse in cold water prior to repair to add working and curing time.
Application:
- Pipe repairs
- offline repairs
- sealing joints
- hazardous material spill control
- reinforce thinning walls
- Abrasion protection
- Structural reinforcement
- Repairs in hard to reach areas
- Underwater repairs
Operating Temperature:
- Continuous – From -29 °C (-20 °F) up to 200 °C (392 °F)
- Intermittent – From 200 °C (392 °F) up to 320 °C (570 °F)
Operating Pressure:
- Recommended for pressure up to 400 psi (28 kg/cm2)
- (Results vary depending on pipe size, type of pipe, hole size, pipe content and method of application)
Applicable Industries:
| Building & Facilities |
Electronics |
Industrial Processing |
| Irrigation |
Oil & Gas |
Chemical |
| Marine |
Military |
Manufacturing Plants |
| Food Processing |
Petrochemical |
Offshore |
| Power Generation |
Pulp & Paper |
Pharmaceutical |
| Wastewater |
Water Distribution |
|
Technical Data:
| Pressure tested |
: |
1/2″ (15 mm) steel pipe with 1/8″ (3 mm) hole when repaired with Wrap Seal withstands 4000 psi (281 kg/cm2) |
| |
|
1/2″ (15 mm) steel pipe with 1/2″ (13 mm) hole when repaired with Wrap Seal withstands 600 psi (42 kg/cm2) |
| Tensile strength |
: |
3920 psi (276 kg/cm2) |
| Bond strength |
: |
230 psi (16 kg/cm2) |
| Tensile elongation |
: |
1.2 % ± 0.7 % |
| Compressive strength |
: |
13750 ± 530 psi (967 ± 37 kg/cm2) |
| Yield strength |
: |
2260 psi (159 kg/cm2) |
| Cured hardness |
: |
82 Shore D |
More detail about KSJ Global Sdn Bhd
Malaysia
