|
Item |
content |
|
Direction of rotation |
Rotation in both directions |
|
Characteristic rang by roller type |
Type |
Tangential speed (m/min) |
Tangential force (N) |
|
1RR500 (φ50) |
1.2~57.6 |
2.29~0.05 |
|
Operation |
Continuous operation |
|
Speed setting |
DIP SW Internal⇔external |
Internal:volume external:0~5V |
|
DIP SW OP Mode ⇔ FB Mode |
OP：volume FB:4 mode |
|
Switching rotation direction |
DIP SW Internal⇔external |
Internal: DIP SW External: Input signal |
|
Protection function (stop) |
Motor open phase operation protection |
Detection of Hall IC fault |
|
Abnormal voltage protection |
Input voltage 80 V or less, 120 V or more |
|
Overload protection |
Restraint state 3 seconds or more |
|
Overheat protection |
Electronic thermal driver 100 ° C or higher |
|
|
|
|
|
|
|
|
Application: Right Angle Transfer, Shuttle, Table Lift, Turn Table Conveyor
Characteristics
●Load capacity
‧ When there is an impact load, please set it to about 1/2 of the allowable load.
‧ Depending on the degree of shock load, the material of the goods to be conveyed, weight, it will differ considerably, so please allow enough margin.
‧ When exceeding the load that can be carried by the roller, please adopt the double row type of conveyor.
|
Approximate load rating (per one) |
|
Total length of the Roller |
450 mm |
550 mm |
650 mm |
|
Load capacity (kg) |
90 |
80 |
70 |
●Mounting
‧ When the outer cylinder of the roller and the shaft have the same diameter as the free roller, the shaft hole of the free roller can be used as it is.
‧ When the dimensions are different, change the shaft hole of the frame to match the height with the free roller, so that the load is even. Depending on the material and smoothness of the material to be conveyed, please increase slightly when not touching the waist roller. In this case, please pay attention to the allowable load sufficiently because the load will be received only by the roller.
●Roller length
‧ There is no standard, but it is required to be about 50 ~ 100 mm wider than the width of goods (or pallet) in principle.
●Specification
Malaysia
