UB2000-30GM-U-V1: Top Choice in Selangor, Malaysia, Kuala Lumpur (KL), Shah Alam Winston Resources

Description

Technical data

General Specifications
Sensing distance	160…2000mm
Adjustment range	200…2000mm
Unusable area	0…200mm
Standard target plate	100mm×100mm
Transducer frequency	About 112kHz
Response delay	About 195ms
Indicators/Operating means
LED blue	Power on
LED yellow	indication of the switching state Flashing:program function object detected
LED red	permanently red: Error Red,flashing:program function,object not detected
Electrical specifications
Operating voltage U B	10…30VDC,ripple10%ss
Power consumption P 0	≤900 mW
Output
Output type	1 analogue output 0…10V
Resolution	evaluation range [mm]/4000, but ≥ 0.35 mm
Deviation of the characteristic curve	≤0.2% of full-scale value
Repeat accuracy	≤0.1% of full-scale value
Load impedance	0…500 Ohm
Temperature influence	≤2% from full-scale value
Ambient conditions
Ambient temperature	-25…70℃
Storage temperature	-40…85℃
Mechanical specifications
Protection grade	IP67
Connection	Connector M12x1,4-PIN
Material Housing	brass,nickel-plated
Transducer	epoxy resin/hollow glass sphere mixture; Polyurethane foam
Weight	60g

Dimension

Connection

External synchronization

The sensor can be synchronised by the external application of a square wave voltage. A synchronisation pulse at the synchronisation input starts a measuring cycle. The pulse must have a duration greater than 100 μs. The measuring cycle starts with the falling edge of a synchronisation pulse. A low level > 1 s or an open synchronisation input will result in the normal operation of the sensor. A high level at the synchronisation input disables the sensor. Two operating modes are available:
1. Multiple sensors can be controlled by the same synchronisation signal. The sensors are synchronised.
2. The synchronisation pulses are sent cyclically to individual sensors. The sensors operate in multiplex mode.

Internal synchronization

The synchronisation connections of up to 5 sensors capable of internal synchronisation are connected to one another. When power is applied, these sensors will operate in multiplex mode.
The response delay increases according to the number of sensors to be synchronised. Synchronisation cannot be performed during TEACH-IN and vice versa. The sensors must be operated in an unsynchronised manner to teach the evaluation limits.

Note

If the option for synchronisation is not used, the synchronisation input has to be connected to ground (0V) or the sensor has to be operated via a V1 cable connector (4-pin).

More detail about Winston Resources