Carbide Burr is suitable for deburring and polishing of cast iron, cast steel, alloy steel and stainless steel etc. up to HRC65 hardness.
Important Notes:
*Workpiece and tools should always be steady and well supported.
Carbide burrs are not suitable for "removing" large amounts of material. They are used for light removal at high rpm's "LOW FEED - HIGH SPEED".
Always ensure that at least 70% of the shank length is clamped by the collet or chuck of the tool being used.
Always ensure that the tool is rated to the recommended operating speed of the burr.
Single Cut
For general purpose usage where fair stock removal and finish are required.
Double Cut
Crosscut/Double cut to improve performance and avoid chipbreaks.
Non-Ferrous
For use on softer non-ferrous and plastic materials such as aluminium, fibreglass, plastics, hard rubber and zinc alloy.
