Stainless Steel Mesh Technical

Stainless Steel Mesh Technical

分类: Measuring Technical 当前有货
欲了解更多详情,请游览我们的官方网站 xtstech.com

详情

Measuring Specification

In order to identify specification for inquiries and orders, please refer to the following steps.

figure:measuring_figure

Please give us detailed conveyor working condition and product be carried in case you are looking for suitable specification for new conveyor system

How to Endless Uni-Flex wire belt

Manual Endless

figure:step1

step1
Remove one piece of wire rod from tail end of belt.
Check the strand direction. The end loop of strand should be in the same direction as the belt end loops. 
 

figure:step2

step2
Bend and Insert the strand in the center of space of wire belt. 
 

figure:step3

step3
Let the straight part of strand bend and curve to interweave the belt.
Try not to twist and deform the shape of Z-bend. 

figure:step4

step4
Insert (※1) arrow marked and push the other side into the belt. Interlock it at (※2) arrow marked point wtih two pliers.
 

figure:step5

step5
Straighten the center space of strand. Insert one side of strand to interlock 2nd space next to center space.
 

figure:step6

step6
Insert around Z-bend as illustrated to interlock perfectly. Straighten the wire. Repeat this procedure till the last space next to end loop. 

figure:step7

step7
Straighten the wire belt roughly. Finish the endless one side completely before starting the opposite side.
 

figure:step8

step8
Put the end loop into the way directed by arrow, and hook up with another end loop.
 

figure:step9

step9
Do the same procudure for the other side of belt and straighten the rod completely.

Applying Joint Sleeve (tubular pipe)

figure:step1

 
step1
Remove a wire rod. Cut even number of spaces of the strand at 3 to 7 where is the position that sprockets and rails are not located.

figure:step2

 
step2
Cut out about 2mm length of the cut piece as illustrated below.

figure:step3

 
step3
Insert cut strands into belt. **Insert a long rod end first.

figure:step4

 
step4
Insert joint sleeve into the cut rods and crimp tightly.
Check carefully the belt face and back when inserting the cut rods.

Climping Tool

We handle the special clipper (crimping tool) and joint sleeve. Please feel free to contact us for details.

picture:clipper

SPACE SPLICING JOINT

SPACE SPLICING JOINT01

SPACE SPLICING JOINT02

  1. 1.Set belts on conveyor with face side (flat-surface) up. Make sure splicing joint piece also has face and back. 
  2. 2.Insert one side of joint piece shown as the above.
 

SPACE SPLICING JOINT03

  1. 3.Connect other side likewise by using pliers.
  2. 4.Each splicing joint should hook at odd columns of spacing.

CONTACT US

  •  
Phone number
+603-8066 2496
E-mail
[email protected]

更多 XTS Technologies Sdn Bhd 相关资料
XTS Technologies Sdn Bhd
XTS Technologies Sdn Bhd Ultrasonic Cleaning System Supplier Malaysia, Robot Automation System Supply Selangor, Conveyor Automation Supplies Kuala Lumpur (KL), Perak ~ XTS Technologies Sdn Bhd