ASTINO BONDECK 680: 马来西亚的首选 CHENG HUAT HARDWARE (SENTUL) SDN BHD

详情

^THE FEATURES AND ADVANTAGES OF USING BONDECK 680 ARE:

Quick and easy construction
Safe working platform
High structural efficiency due to high strength steel used
Stiffens supporting frame in tall steel buildings
Excellent spanning capacities for greater strength and less deflection
Act as a permanent formwork with minimal propping and no stripping of formwork face is required
Works as composite slab saving on concrete and reinforcement costs
Advanced design for fire resistance
Can be used on steelwork, concrete, block work and masonry structures
Backed by supplier’s warranty

^BONDECK 680 IS RECOMMENDED TO BE USED FOR:

Concrete frame building
Residential construction
Multi-level car parks and multi-storey building
Commercial building
Shopping Centre
Storage Levels

MATERIAL SPECIFICATIONS

PRODUCT SPECIFICATIONS

THICKNESS AVAILABLE

SPECIFICATIONS

FORMWORK/SHUTTERING/SLAB SPAN TABLE

BONDECK 680 SHEETS CONTINUOUS OVER SINGLE SPAN SLAB

FORMWORK DEFLECTION LIMIT L/240 (OR<30MM) VISUAL APPEARANCE IMPORTANT

BONDECK 680 SHEETS CONTINUOUS OVER SINGLE SPAN SLAB

FORMWORK DEFLECTION LIMIT L/130 (OR<30MM) VISUAL APPEARANCE NOT IMPORTANT

FORM/SHUTTERING/SLAB SPAN TABLE

BONDECK 680 SHEETS CONTINUOUS OVER TWO SLAB

FORMWORK DEFLECTION LIMIT L/240 (OR<30MM) VISUAL APPEARANCE IMPORTANT

BONDECK 680 SHEETS CONTINUOUS OVER TWO SLAB

FORMWORK DEFLECTION LIMIT L/130 (OR<30MM) VISUAL APPEARANCE NOT IMPORTANT

FORMWORK/SHUTTERING/SLAB SPAN TABLE

BON DECK 680 SHEETS CONTINUOUS OVER THREE OR MORE SLAB SPAN

FORMWORK DEFLECTION LIMIT L/240 (OR<30MM) VISUAL APPEARANCE IMPORTANT

BON DECK 680 SHEETS CONTINUOUS OVER THREE OR MORE SPAN SLAB

FORMWORK DEFLECTION LIMIT L/130 (OR<30MM) VISUAL APPEARANCE NOT IMPORTANT

NOTE: THE SPANNING TABLE ABOVE ARE BASED ON THE FOLLOWING ASSUMPTIONS AND CONSTRAINTS:

Density of concrete is assumed at 2400kg/m3.
The sheets shall be fully supported across the full width and shall have a minimum bearing 50mm at the end of the sheets and 100mm at intermediate support over which sheeting is continuous.
Construction load of 1.5kPa is assumed.
Deflection limit of Span/130.

BONDECK 680 SHEETS CONTINUOUS OVER SINGLE SLAB SPAN

BONDECK 680 SHEETS CONTINUOUS OVER 2 SLAB SPANS

CEILING SUSPENSION SYSTEM

>A heavy duty square nut adhered to a paper strip to allow easy insertion from below into Astino Bondeck 680. Threaded rods may be then screws into Bondeck 680 and locked into position.
The nut is available in three convenient thread sizes (M8, M10 and M12), and may be used to support threaded rods for various services and suspended ceilings.