703.4.1 Height Above Finish Floor or Ground. Tactile characters on signs shall be located 48 inches (1220 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest tactile character and 60 inches (1525 mm) maximum above the finish floor or ground surface, measured from the baseline of the highest tactile character.
EXCEPTION: Tactile characters for elevator car controls shall not be required to comply with 703.4.1.
703.4.2 Location. Where a tactile sign is provided at a door, the sign shall be located alongside the door at the latch side. Where a tactile sign is provided at double doors with one active leaf, the sign shall belocated on the inactive leaf. Where a tactile sign is provided at double doors with two active leafs, the sign shall be located to the right of the right hand door. Where there is no wall space at the latch side of asingle door or at the right side of double doors, signs shall be located on the nearest adjacent wall. Signs containing tactile characters shall be located so that a clear floor space of 18 inches (455 mm) minimum by 18 inches (455 mm) minimum, centered on the tactile characters, is provided beyond the arc of any door swing between the closed position and 45 degree open position.
EXCEPTION: Signs with tactile characters shall be permitted on the push side of doors with closers andwithout hold-open devices.
IN SIMPLE TERMS:
When installing an ADA (Americans with Disabilities Act ) compliant braille sign, the braille and tactile characters of the sign must fall between 48" and 60" from the floor. Remember the baseline (or bottom) of the highest line can be no higher than 60", and the bottom text, measured from the baseline of the lowest tactile character, can be no lower than 48".
Location - Refer to the drawing below:
Installers should use an 18 in square jig or template and locate it by doors that open outward. Be aware that the space must be free from obstructions and clear so the reader can approach the sign. Do not install signs where readers can be hit by an opening door. For even further explanation, refer to the drawing below:
Sign Compliance/Disclaimer/Additional Limits of Liability & Warranty
This website is not intended to be a comprehensive authority or information resource on sign codes and regulations. User agrees that the use of www.printmy.my is at their sole risk, and we make no warranty regarding the accuracy, reliability, or currency of any information, content, service, or merchandise provided. User and buyers are solely responsible for compliance with all applicable laws, rules and regulations. Signs, photos, drawings, pictures and all reference material and information provided is meant to be a resource for additional information, guidance, training, but not considered to be comprehensive nor construed in any way as legal advice or recommendations.
No information contained herein shall create a warranty; nor shall User rely on any such information, as this website is “AS IS” and without warranty of any kind, expressed or implied.
The requirements for sign content/text, construction and design are determined by intended use and by applicable regulation, and it is the buyer's responsibility to determine if their products purchased are compliant and installed correctly. The BUYER shall be responsible for determining the appropriate content, appearance, design, construction and installation for all signs and signage. The buyer shall also be responsible for determining whether or not received and/or purchased signage meet, and is in compliance with, any and all applicable city, state, federal, ADA / ABA sign codes, laws, requirements and regulations. PRINTMY SDN BHD is not , and shall not be held liable for costs, fines, hardships, law suites and/or any other monetary expenses/liabilities associated with, or as a result of, code failure, signage noncompliance or other sign violations, or any other monetary hardship, as it relates to our products, services, advice or recommendations.
Malaysia