Below, SWOER tell you how to clean some vibratory bowl feeder. The method is as follows:
Wipe clean the grease, oil and lubricating oil on the surface of the vibratory bowl feeder with a soft cloth, and then clean with a neutral detergent or ammonia solution or with a special detergent.
The surface with dust and dirt can be washed with soap, weak detergent or warm water. The surface of the trademark, film, washed with warm water, weak detergent, these adhesive ingredients, should be scrubbed with alcohol or organic solvents.
The rust caused by surface dirt can be washed with 10% nitric acid or grinding detergent, or it can be washed with special washing drugs.
If the surface of the vibratory bowl feeder has rainbow pattern, which is caused by excessive use of detergent or oil. It can be washed with warm water detergent when washing.
The surface of the vibratory bowl feeder is bleached and various acids are attached. Rinse immediately with water, then dip with ammonia solution or neutral carbonated soda solution, and wash with neutral detergent or warm water.
Vietnam
